So you have your Fisher F2, but you don’t know how to set it up. Well here are a few tips on how you can program the Fisher F2 metal detector. Really what program you use depends on what type of hunting you plan to do that day.
Coin shooting is when you only want to find coins. Most parks and playgrounds are littered with coins and that’s a good thing because the Fisher F2 is a coin magnet! To set up the coin mode on the F2 it is really easy, and this is how I do it:
* Press the Discrimination button up Four times. This will eliminate Iron, Foil, Nickel and Tabs.
* Next, Press NOTCH button and then Press Discrimination UP Three times, to Notch the Nickel back in. Then, Press the Notch button one more time to lock in and set the program. Now you will only be searching for Nickels, Pennies, Dimes, and Quarters! That is the coin mode.
There is no true All Metal mode on the F2, but you can run your machine in Relic Mode. That is, you do not use any Discrimination at all, and dig it all. This mode is useful for when you are detecting areas like Civil War camps that have the potential for all types of metal targets to be found.
What I call the jewelry mode is how I normally run my F2. Basically, I discriminate iron, Use MAX Sensitivity and start swinging.
To run in Jewelry mode:
* Press the DISCRIMINATE button Up once, which eliminates iron targets.
* Then, Press the SENSITIVITY button Up once, making the machine maximum sensitivity and start swinging. That’s all there is to it.
In all of these modes, what you are listening for is a Repeatable signal. What is a repeatable signal? Any signal that gives you a tone Both ways of your swing. In jewelry mode, a good target can be found in any target range from foil all the way up to quarter. You just have to dig the solid repeatable signals and eventually you will be rewarded with a nice find.
What I like to do is what is called the X technique. Once I find a target I want to dig, I turn my body 90 degrees and swing over the target again. If the signal repeats, I make a visual note of where the target is in the center of the X and then I dig. Note the Depth of the target on your depth meter on the right of your screen. Normally each bar represents 3 inches. The target is going to be in the center of your coil.
Obviously you can Discriminate or Notch In any combination of target ranges that you like, but in my experience these three modes will fit just about any situation. If you get tired of digging tabs, well, just discriminate tabs. If you get tired of digging foil, just discriminate foil.
It’s your machine, run it how you want to!
I hope that these tips on the Fisher F2 Metal Detector help you enjoy your new hobby and machine even more!
Thanks for reading… Happy Hunting out there!